Using Rufus or Win32 Disk Imager has one disadvantage though. Previous versions could only be installed when running a Linux system. This version can be installed in Windows using Rufus 3.20, Win32 Disk Imager or Etcher. Most important change in version 221127: Use Rufus 3.20 to install RaspArch to the SD card It must be installed on a Raspberry Pi 4, Raspberry Pi 3 Model B+, Raspberry Pi 3 Model B or Raspberry Pi 2 Model B computer. After I have added the LXDE Desktop environment, PulseAudio, Firefox, Yay, Gimp and NetworkManager the system has increased a lot. The original compressed system is of about 230 MB. RaspArch is a “remaster” of Arch Linux ARM. You will probably notice a big difference. Just replace /boot/config.txt with the one I’ve provided – see above. NOTE: If you already have installed RaspArch Build 221127 you don’t have to reinstall. Watch this screenshot when I’m using a 3440×1440 (Ultrawide) monitor. The new configuration makes the system automatically choose the best possible resolution for your monitor. I’ve replaced /boot/config.txt with this file. I have uploaded a new version of RaspArch after I’ve discovered a better way to configure the system. This version (221127) is especially made for the “new” Raspberry Pi 4, but it can of course also be used on a Raspberry Pi 3 Model B+, Raspberry Pi 3 Model B and Raspberry Pi 2 Model B. RaspArch Build 221127 especially for the new Raspberry Pi 4 released in May 2020

Rasplex